AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Ontrac2+ Combine Settings
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
STFB
Posted 10/9/2020 09:20 (#8537356 - in reply to #8537194)
Subject: RE: Ontrac2+ Combine Settings


Northwest Ohio
sunman - 10/9/2020 07:03

I had one that was getting excessive vibrations from the mounting location. Moved it to the rubber mat on the floor and it was much better. I used some sheet metal screws just into the rubber so it would not slide around. For some reason, I think they run better with connectors pointing forward or back....not to the side, but that's just my preference. Min motor output is usually 18-20 range.


I used thick double sided foam tape to mount the plate... hoping to absorber alot of the vibration.

It recognizes it over correcting but then it just keeps over correcting more. i might try the orientation as well. thank you
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)