AgTalk is committed to operating without commercial advertising. Our fall donation drive is now open.

AgTalk Home
AgTalk Home
Search Forums | Classifieds (6) | Skins | Language
You are logged in as a guest. ( logon | register )

Ontrac2+ Combine Settings
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
sunman
Posted 10/9/2020 08:03 (#8537194 - in reply to #8537087)
Subject: RE: Ontrac2+ Combine Settings


North Central Ohio
I had one that was getting excessive vibrations from the mounting location. Moved it to the rubber mat on the floor and it was much better. I used some sheet metal screws just into the rubber so it would not slide around. For some reason, I think they run better with connectors pointing forward or back....not to the side, but that's just my preference. Min motor output is usually 18-20 range.

Edited by sunman 10/9/2020 08:05
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)