|
Pierce county WI | So I am getting things ready for corn and wanted to service the dryer and set everything up. When testing, I can't get the load control to start unless I push in on the relay. Once I push on it, it stays in. The unload circuit works good. The wet grain timer and the fill timer both start. Is there something to clean or adjust? Also what size drill bit to clean the orfices in the burner? Anything else I should do besides greasing and oiling feed roll chain?
(16013147703929063700532048833408 (full).jpg)
(16013147926377428233851544106344 (full).jpg)
Attachments ---------------- 16013147703929063700532048833408 (full).jpg (106KB - 265 downloads) 16013147926377428233851544106344 (full).jpg (87KB - 155 downloads)
| |
|