AgTalk Home
AgTalk Home
Search Forums | Classifieds (1) | Skins | Language
You are logged in as a guest. ( logon | register )

Getting radar output from cfx750 to microtrak gsc1000
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
tedbear
Posted 9/9/2020 05:23 (#8484269 - in reply to #8482504)
Subject: RE: Getting radar output from cfx750 to microtrak gsc1000


Don't call it a 'gator, it's a Ranger
TiminIN - 9/8/2020 08:41

Thanks Ted. Do you think it's possible to come off the deutsch plug on the end of the harness? I have some misc plugs to fab a harness from.


If pin #2 is present at the end of the harness that should be fine. I would doubt that it is. If pin #2 has a dust pin in it at the connection to Port A, you could remove the dust pin and add pin #2 to the harness you already have. Trimble uses several harnesses for various purposes. Some have a branch called a port replicator. These branch all the pins off so that yet another harness can be plugged in.

In my case, I was using auto pilot with a Nav II which connected to Port B and there was no plug in Port A. I made a harness for Port A from scratch. It used Pins 2 & 10 for radar out. It used Pins 11 & 10 for a coverage map relay. It also used 3 pins for a video camera.

Edited by tedbear 9/9/2020 05:27
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)