AgTalk Home
AgTalk Home
Search Forums | Classifieds (119) | Skins | Language
You are logged in as a guest. ( logon | register )

CIH combine error code after ag leader install.
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
tuckylamb
Posted 9/3/2020 03:55 (#8473281 - in reply to #8468561)
Subject: RE: CIH combine error code after ag leader install.


In CNH a -05 fault is usually a broken wire or something is unplugged.
That sensor is at the base of the steering column and picks up movement.
It is wired straight to one of the CCM computers
I have seen that harness rub through at the base of the column.
I have seen it unplugged.
I am not sure what your ag leader system install involved but i am suggesting that either its been unplugged or harness damage.
If it was disconnected as part of the install you may have to install a dummy sensor to stop that alarm from happening.
It also uses that sensor to disengage your turn signal when in road mode if i remember correctly.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)