|
north central kansas | trying to connect to a Versa so I can use for coverage mapping with my drill using an implement switch. I see switch comes out of AUX but which CAN connection do I use? Currently have a harness going to a Clutch Control Module that is not being used for the drill. Can I pull out the Terminator and use this? I highlighted it on the diagram.
Edited by pfortfarm 8/26/2020 17:45
 (Capture (full).JPG)
Attachments
----------------
 Capture (full).JPG (57KB - 88 downloads)
| |
|
application rate module connections diagram?
