Posted 8/14/2020 20:20 (#8435597 - in reply to #8433750) Subject: RE: NanoStation antenna setup
I’m gonna go through this as I understand it and try to direct you and you can let us know if it’s out of whack.
Your internet is at the barn and needs bridged to house.
The entire(?) barn network is 192.168.168.x...there is THE router and a switch and it outputs the 168 subnet.
A is the AP that needs to be at barn and B is station at house. They can be assigned any static address that is not already in use. Both STATIC.
I would then setup the router in the house to AP mode and it should also operate as a switch. I would start with connecting it to the LAN side but depending on model and function of the WAN port when in AP/switch mode then it may need to connect to it. Your router in the house if not setup this way is sending it’s own addresses to the clients in the house and thusly ‘hiding’ the barn clients.
This may either help you or allow someone else to chime in with better guidance.