|
sw ontario | Close your slide and Pull your anchor bearing and flex auger right out the bottom and then just slide it back in .....What size flex? We run nursery pellets through a 350 flex with 2 curves and never (geexz I hate to even say that) plugged them......now on finisher barn they installed 350 tube with 300 flex auger becuse of HMSC feed. Yes u can run backwards with drill, pipe wrench,ect. and as long as u keep fingers out of flex u will be fine as when u turn it plugged or full of feed it builds some spring spin pressure....if its a 300 flex try using a 350 tube for the curve (just takes some cutting/engineering a coupler and glue) ...pellets should never plug a flex, we always find something else,chunk hard feed, rat, feed drivers glove,ect. stuck in middle of flex | |
|