|
Le Sueur VIA St.Thomas | Hello,
When I finished my garage a dozen years ago I added a 28" pvc conduit from my breaker panel straight down into my basement so I could easily run wires into my basement someday. Well, 'Someday' was yesterday... It's just that now I don't think the inspector will appreciate it as much as I do. Check out the pics of both ends. Is this going to pass? My 'electrician' is coming tomorrow, but you guys are smarter than him :^)
Plan B is to cut out the rock below my panel in the garage and do it the 'right' way with knockout clamps for the romex. I don't want to fail inspection and have to wait for him to come back. Should I ditch the pvc and go with clamps? Can I use the same big hole in the bottom plate to run the wires or will the inspector not like that , either?
good luck -jim
 (Conduit top (full).jpg)
 (Conduit bottom (full).jpg)
Attachments
----------------
 Conduit top (full).jpg (130KB - 211 downloads)
Conduit bottom (full).jpg (132KB - 205 downloads)
| |
|
Am I going to fail my MN State electrical inspection? Pics
