|
Orange Grove, TX | Hello. I'm a long time lurker, taking in all the info I can. Reading through some of the threads has helped me more than once. But now I have a problem with my 566 baler.
Up top there is a roller, the one that moves up when you open the gate (Belt Staggering and Arm Roll). Lost a bearing and can't get the bearing off the hex shaft. I'm presuming it is just pressed or slid (tightly) on the shaft as I can't find anything holding it. I used a puller, figured it would pop it off but nope. Added a little heat and impact (a strong one) on the puller, still won't budge. I'm guessing I'm going to have to get out my other torch and cut it off? As sitting in the tractor, it's the right side. Left side it still attached. Anyone have any idea how I can get this thing off?
Edited by DJC62 5/30/2020 20:43
(roller (full).jpg)
Attachments ---------------- roller (full).jpg (34KB - 146 downloads)
| |
|