Marshal County, Minnesota | I have always been of the mindset, upgrade the stock lights before adding extra ones. On my 4640 I installed LED's in all of the stock locations I also re-wired the the Hi/Low light to be on the inside of the fender and the flood light to be on the outside. I also re-cut the hole on the outside so I can point that light as far off to the side as possible. I also cut the front off of the half moon cowl of those lights on the inside and put a normal flat cowl on the outside, this way, the most light shines on the ground instead of being blocked by the cowls. I see I don't any really good pictures of this set up but here is 1 from this past summer when I put LED's on the roof and rewired my grain cart with LED's as well, you should be able to understand what I am talking about in the picture. I am not a fan of light bars on the roof, light gets reflected off of the muffler and air intake and onto the glass and creates a glare.
(IMG_20190728_211853 (full).jpg)
Attachments ---------------- IMG_20190728_211853 (full).jpg (111KB - 13 downloads)
|