Riverwood - 4/7/2020 12:31
Just brought home a 4800 cultivator. The hydraulic cylinders are out of timing and lift and lower out of sequence resulting in cultivator leaning to one side. Have tried holding valves but no luck. Any advice would be appreciated
Just went through this last year on a new to me 4800. Mine has a supply hose the runs from the SCV back to a T then the fluid splits and flows to each side is series.
I checked all the stuff that the guys mentioned in this thread ...but to no avail. Turned out a couple of the cylinders didn’t have enough oil in them. | 
Case 4800 cultivator
