|
Ohio | I put a steercommand in or 665d. I bought the agleader bracket to mount the ECU controller. If you remove the big side panel by the window you will find a spot to bring power in the cab. You can also tie up any left over cable under there. Then I removed the back panel where the key is. I had to tie into the factory harness there I also ran the display cable up there and out the hole that was in the side. For the gps cable I originally ran in up the corner post in the back with the display cable and out the top of the window but when it would rain it would leak by the window seal a bit so this winter I dropped the headliner in the back of the cab and ran the gps cable out the roof in the same hole the wire goes out for the lights. It took a little work but I think I will be a lot better.
(20200404_093206 (full).jpg)
(20200404_093232 (full).jpg)
Attachments ---------------- 20200404_093206 (full).jpg (183KB - 53 downloads) 20200404_093232 (full).jpg (219KB - 52 downloads)
| |
|