Precision does not currently have an adapter cable to go into from Raven into their flow sensor harness 727303. It is setup to plug into the MicroTrak flowmeters that PP distributes. That being said I have made a Raven Flow Meter work because it is a digital output just like the MicroTraks. Had to cut the round amp connector off and put on a weatherpack connector to make it work. Then, you just have to take the K factor posted on the Raven and drop the last digit off so it is pulses/gallon rather than pulses/10 gallons when you set it up in the Gen3 Gen 3 software 2020.1.1 will be available tomorrow and should let you connect the flow meter independent of a rate Control module from Precision.
Edited by prairiedogger 4/2/2020 19:07
|