|
| I have run a pro 700 in a Case Ih Mx 340 to apply anhydrous using ISOBUS for the last 2 years. We purchased a Mx 380 this winter, added a Pro 700 planning to use it for anhydrous. Case Precision guy has been out 3 times and cannot get the bar controls to show up on the pro 700. We first thought it was an issue on the bar side so we pulled the 340 in front of the bar that I used last fall and it came right up when plugged in. Then he thought it was the plug on back of tractor. Replaced that with no results. The last thing we tried is the terminator plug on back of tractor also with no results.
The tech has been in contact with higher ups but no one seems to have an answer. Any help is appreciated! | |
|