AgTalk Home
AgTalk Home
Search Forums | Classifieds (9) | Skins | Language
You are logged in as a guest. ( logon | register )

Raven PWM valve questions
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Amc4life
Posted 3/23/2020 10:04 (#8131647 - in reply to #8131386)
Subject: RE: Raven PWM valve questions



Butterfield, MN
You've got yourself an interesting project here.

1. I think you're right. Do it like a split bed with dual encoders.
2.The product control node should be outputting 12 volts on these two pins based on sections 1 and 2 for doing exactly what you're talking about. I've never hooked anything up this way, but if the current draw isn't too high, that's how it's supposed to work.
3. This is going to depend on the valve type you have programmed in. If it's programmed as PWM, the valve will stay at the current position until you turn the product off. If you program as PWM Close, then it will also shut down when you turn the master switch off.
4. I'm not sure what you mean about PWM on an NH3 cart, but on the air cart it would be the same as on question 3.

Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)