AgTalk Home
AgTalk Home
Search Forums | Classifieds (2) | Skins | Language
You are logged in as a guest. ( logon | register )

DD-WRT router configured in Client mode? How to re-configure?
View previous thread :: View next thread
   Forums List -> Computer TalkMessage format
 
dpilot83
Posted 3/9/2020 15:48 (#8092077 - in reply to #8092058)
Subject: RE: DD-WRT router configured in Client mode? How to re-configure?



I re-read your post and I don’t know how to answer your last question.

My networking knowledge is extremely shaky.

I am confident that the normally configured router is always 192.168.1.1 because I can always easily access it if I want to. It’s just that when I connect the Ethernet cable to a LAN port on the repeater bridge configured router (that has an address of 192.168.1.9) I cannot connect to it.

It is strange though, as I am working on it now, I am physically connected to the 192.168.1.9 and am able to access every dd-wrt page. That router is connected to my wife’s iPad and is sending that signal to the 192.168.1.1 router and I am wirelessly connected to the 192.168.1.1 router with the wireless card on my computer.

So I can browse the internet via the wireless connection and I can configure the 192.168.1.9 router with the wired connection of the same computer.

Based on last time I’m expecting that as soon as I physically disconnect from 192.168.1.9 and physically connect to 192.168.1.1 so I don’t have to use the wireless connection anymore, then I will no longer be able to hook back up to the 192.168.1.9 device by physically connecting to it again and typing that IP in.

Not going to do that until I get my screenshots done.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)