|
| Appendix D in the 332 manual covers a lot of third party interface requirements. If you have CAN yield monitor (I dont know what you have and NH has both types) is seems that it should auto-configure, but I would guess that configuring that port as can bus is required first. If it is not a CAN type, turn anything not required off. Make certain you try turning RTS/CTS off. This is a serial handshaking routine that makes the 332 wait for a signal from the device connected to it before sending any data. If there is a reference to this in the manual I never found it. Your dealer can contact Trimble for help if you still have trouble. | |
|