AgTalk Home
AgTalk Home
Search Forums | Classifieds (67) | Skins | Language
You are logged in as a guest. ( logon | register )

shop floor ideas
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
evilboweivel
Posted 7/12/2019 08:14 (#7610313 - in reply to #7610210)
Subject: RE: shop floor ideas


Lancaster, Ohio
Steel beam would be good, along with sections about a foot long that have rebar fastened to them spread out.
Ground the beam and any other steel pieces in the floor back to your welder.
Consider making that section of the floor perfectly level and flat so that you have a fabrication area.
A in ground lift recessed in the floor is very handy yet out of the way when not wanted.
Angle iron at the doors can help protect the concrete edge
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)