AgTalk Home
AgTalk Home
Search Forums | Classifieds (178) | Skins | Language
You are logged in as a guest. ( logon | register )

Best corral paint
View previous thread :: View next thread
   Forums List -> Stock TalkMessage format
 
Nickeischeid
Posted 7/10/2019 21:24 (#7607782 - in reply to #7607268)
Subject: RE: Best corral paint


North central TX
dabeegmon - 7/10/2019 16:27

ntexcotton - 7/10/2019 15:49

You have to let the pipe set and cure if it's been used for a few years on a rack in 100° Texas sun. The paint will stick right to it then. So technically we bake it.


Sorry - - - - forgot you have an over sized baking oven (grin!).
Grew up in that oilfield country of the north and we didn't have that oversized oven.
Pipe that was pulled from a sour gas well, or a high salt water crude well - - - - well let's just say that welding that even with 7018 was fairly challenging.
Like the steel had absorbed some of the junk from in the well (sulfur and salt water salts for 2).


If it wouldn't weld then it was probably magnetized from being down hole. I've run into that on a few occasions. Not super common around here luckily. Most of our old wells are super high saltwater percent so the normal issue is finding splits and holes after you've welded them in...
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)