AgTalk Home
AgTalk Home
Search Forums | Classifieds (89) | Skins | Language
You are logged in as a guest. ( logon | register )

Moving Nav controller between machines?
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Trimble Man
Posted 7/7/2019 03:12 (#7601074 - in reply to #7600365)
Subject: RE: Moving Nav controller between machines?


You don’t have to load a profile into the nav on a CNHI steering system. The profile is selected in the Pro700, then the settings are sent to the Nav each time the key is turned on. Just moving the Nav between machines should be quite simple, as long as both displays are running the same firmware sets. Sometime combines can be an issue here, since other hardware on the combines can dictate the highest level of firmware that can be run on the display. Check with your dealer on the firmware.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)