|
West Central Iowa | The upper rear drive shaft that goes through the feed roll gearbox on my 3800 chopper has a bad bearing. Looks like a bear to get out. It looks like I can take a snap ring out that connects the halves where the shear bolts go and also remove the roll pin that holds the overrunning clutch in place. Unfortunately, after removing the roll pin I can't get the inner portion of the overrunning clutch to slide more than an inch on the shaft. Any advice on dismantling the driveline, or any of the other components that drive the feedrolls in efforts to remove it for repair?
(KIMG0513 (full).JPG)
Attachments ---------------- KIMG0513 (full).JPG (206KB - 39 downloads)
| |
|