AgTalk Home
AgTalk Home
Search Forums | Classifieds (181) | Skins | Language
You are logged in as a guest. ( logon | register )

Cat 3126 no start problem
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
John.jr
Posted 6/12/2019 22:58 (#7556080 - in reply to #7555987)
Subject: RE: Cat 3126 no start problem



Fancy prairie, Illinois
Local truck dealer that used to sell gm HD didn't have a cable, and neither did cat dealership, but the guy at the cat dealership also said theres a 9 pin Deutsch so I'm not too sure about his information.

The hand primer acted normally, firm to push in, the fuel transfer pump was actually replaced about 6 months ago. Pumps plenty of fuel out of the plug on filter housing

I ran it on ether for a few seconds more than enough to purge any air in fuel or oil.

I haven't pulled valve cover yet.

I'll check out the wiring on the timing sensors more closely tomorrow.

In my tests today I checked solely with a meter, I'll wire up a light tomorrow.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)