Posted 6/12/2019 21:27 (#7555851 - in reply to #7555250) Subject: RE: Raven Viper Pro rate hunting
One thing to keep en eye on is your sections when it “blips”
I had a bad wire on a boom section valve that made the valve flutter. Now it was pretty fast, but eventually I noticed the green section number wink once in a while when the rate bounced. The controller was reading that as a section switch opening and closing rapidly, and was attempting to compensate for that.
This break in the wire was just a few inches from the plug for the section valve, where there was a bit of wire exposed outside the loom. The insulation had been cracked and some fertilizer from side dressing had corroded the wire inside the insulation.