Posted 6/12/2019 07:27 (#7554604 - in reply to #7552549) Subject: RE: Trimble - Case 750 issue
I would assume you went to settings and made a configuration change. Maybe your dealer made this change for you earlier. In other words you went to a different machine completely and you should have a configuration for both in 750. I move mine to four different machines and each has it's own configuration. These were saved the first time I did a configuration calibration for each machine and implement combination. It is then a 30 second deal to go to saved configurations and hit the one setup you have moved to. Sounds complicated, but becomes quite simple once you save it the first time. Good luck. I am sure a dealer could explain it much better than I. It is in the manual if you could pull it up from web sight, but we all know about Trimble manuals for ease of use.