Posted 6/10/2019 19:47 (#7552150 - in reply to #7551972) Subject: RE: Raven Epro section issue
The node, I'm assuming, is inside the cab, since you have a 660, so that should eliminate the possibility of the node getting water in it. You should be running with your master switch on and the boom switches shut off with a 660 in the mix. That's the confusing part, when you're running it this way, the AccuBoom node is the thing that HAS to send voltage out to open the boom valves. Since it shuts off with the master switch, the voltage outputs from the node are all turning off and the boom valves shut. Since the boom sections on the Envizio Pro are indicating that the sections are turning off, it has to be something else acting up. If you go into the tools page and select Control Interface, is there a check mark in the box for AccuBoom Combo Node? There should not be.