|
Lancaster County, Pa | To start over, unplug all sensors...Power up monitor and it will read no sensors..Hold ok and it will beep three times asking new system...Then plug sensors in sequentially, monitor recognizes row by sequence you plug them in... Every time a sensor registers u hear a beep... Pickup and shaft sensors can be plugged anytime in the sequence..Should hear beep also...After all plugged,hold ok to get beep series again asking to save...Follow suit for front rows,then hold ok to save..Then follow distance calibration
I wouldn't be surprised if the problem may be bad connection in harness or at plug where pickup is plugged into.. Fertilizer in there can turn them bad quick...Simply plug into another plug to see if it reads sensor for quick diagnosis..All plugs are wired parallel so doesn't matter which one you pick.
If you lost connection to pickup you would get speed error though
Also there is a pigtail that comes along with monitor to adapt to radar.. Occasionally people plug these in and monitor looks for radar when the pigtail is plugged in.. Again the monitor will briefly read what sensors are online in bootup process
Edited by dairyZman 5/25/2019 20:05
| |
|