Posted 5/25/2019 09:37 (#7519893 - in reply to #7518860) Subject: RE: Shop built puller for geringhoff rotadisc rolls
God's Country (N.C. Ia)
Hello. I imagine an acme screw would work fine as well. I just used some threaded rod I had on hand. As far as the air wrench goes, I'd be a little worried about wearing out the threads on the screw a little prematurely due to the higher speed. Would be lots easier on the shoulders though:) thanks for the reply.
Shop built puller for geringhoff rotadisc rolls
