|
NE Nebraska | I feel for you being 3 hrs from your dealer, can’t imagine much over an hour round trip for too much around here. The only other thing I will suggest is to check the planters seed harness. The one from the power module to all the rows. There should be common power and grounds between the rows and the a signal to each row. I had a planter I chased a row flow hydraulic drive issue 2 seasons. Would act crazy until I showed up. Tried ever harness, power source, ccm, terminator, etc. and could never solve it. Finally started digging into the seed tubes and noticed bare wires. They weren’t touching but would seem to be affected by humidity and moisture.
Found out planter had sat on lot in Arizona for a couple years prior to them buying it.
Good luck. | |
|