AgTalk Home
AgTalk Home
Search Forums | Classifieds (66) | Skins | Language
You are logged in as a guest. ( logon | register )

Issues with 1770NT CCS - RowCommand
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
TheDude
Posted 5/15/2019 23:35 (#7499359)
Subject: Issues with 1770NT CCS - RowCommand


South Central Minnesota
Planting at 5mph and 1/2 of my 16R planter will just stop planting. Sometimes the clutches on rows 1-8 and other times it is 9-16 will just randomly shut off. It is never individual and only one half or the other. It is driving me nuts and am likely going to have to call Deere in the morning. I can go 30 acres sometimes and have zero issues. Other times, it will give me trouble multiple times in the same round. If I lift planter, back up to before where the 8 rows shut off, it will start up fine again sometimes and pick up again with all 16 where needed.

I've checked all connections and I just can't figure it out.

I did happen to notice in this last field that the error code: "CAN bus subnet communication error. These sensor nodes are online but not responding to CAN bus messages: 1". I have not noticed this before and still seemed to have issues.

Any help would be appreciated.



Edited by TheDude 5/15/2019 23:36
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)