|
| So running a C-Ih 1245 planter with cable drive and electric clutches. We are getting GPS through a Trimble 750 feeding our Pro 700. Well, we did a no-no and accidentally pulled thumb drive out of Pro 700 while powered up and lost almost all our calibrations that we had set on planter. All the clutches seem to be working, but to do that, had to fudge with measurements from top of cab (where beacon is mounted) and the rear axle measurement to seed tubes. I'm off probably 30" to make clutches work properly. Another thing is on the cable drive there is a red light on top that indicates when cluthes are applied. The left 8 rows will light up, but right 8 do not even though the cluthches are on. I noticed this while putting in a test plot the other day. Also, while planting, the 750 would paint the screen while planting and is not doing that anymore. I think all these things are tied in together somewhere and not sure where to start looking. Any ideas ? Thanks. | |
|
Pro 700 and Trimble 750
