|
Northwest Ohio | So i added hydraulic drive onto my planter. It had clutches, stmm, and liquid products module. the implement switch is on the hydraulic drive module.
I can't get any of the rows to turn green, just grey or red when the switch is off. I can get the hydraulic drive to work in manual and opening the valve, after switching the lines in the remote.
i think i have the drive motor installed backwards. i can not perform the calibration because it won't turn the shaft.... but i can switch it back to manual and open it up.
So im assuming i can't get the rows to turn green or rate control until i calibrate..... and i can't calibrate until i flip the drive because its not dropping seed now.
any insight would be greatly appreciated.... and yes i tried jumping the implement switch
| |
|
|