AgTalk Home
AgTalk Home
Search Forums | Classifieds (137) | Skins | Language
You are logged in as a guest. ( logon | register )

Building a High-Lift Jack?
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
paul_m
Posted 3/16/2019 02:01 (#7383291 - in reply to #7382857)
Subject: RE: Building a High-Lift Jack?


SW Ontario
You could use a smaller inside tube but add wear pads in the right spots to make up the proper fit. Just avoid the seam from the outside tube with the pads.

I'd be tempted to make this some kind of C profile with the jack directly in the center to avoid binding. Or have two C channels facing each other. You'd need a different way to lock it though as the jack would be in the way of a straight through pin.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)