|
SW MN | I just finished installing another one of these myself. You will be able to get all of that through the tube. First clip all of the ties and remove any clamps on both ends. Then take a long screwdriver or a pry bar and try any scrape all of the dirt off the bottom of the tube as far into the opening as you can reach. After doing this to both sides take a blow wand and blow as much out as you can. You will then be able to lift the bend of the hose on either end and push down through the opening to get the hoses to ride in the bottom of the draft tubes. Push a fish line through. I attach the large plug first , then stagger everything about 12" between each other and feed everything at the same time. I try to put the hose on the bottom and have a second guy keeping everything fed straight so it comes out just like it goes in. It really goes better than you think...amazes the guys everytime | |
|