AgTalk Home
AgTalk Home
Search Forums | Classifieds (164) | Skins | Language
You are logged in as a guest. ( logon | register )

Moving snow equipment
View previous thread :: View next thread
   Forums List -> Stock TalkMessage format
 
MiradaAcres
Posted 3/14/2019 23:39 (#7381436 - in reply to #7380637)
Subject: RE: Moving snow equipment



Southern MN
Track off a MT800 Challenger

The frame on this one is an I-beam others I have built used angle iron. With the angular you can pre drill the holes in the metal and then only have to drill through the track. I found using a concrete bit in a hammer drill works well to punch a hole through then use a drill bit a couple size larger than the bolt; using a bit the same as the bolt makes it difficult to get the bolt in because the rubber does not get drilled out the correct size.

I originally built this one to go on my loader tractor and then put the top link on to use it on the 3 pt. 148 loader arms are the same width as Category 2


Edited by MiradaAcres 3/15/2019 10:34




(IMG_20121226_094820 (full).jpg)



Attachments
----------------
Attachments IMG_20121226_094820 (full).jpg (152KB - 22 downloads)
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)