|
| Is pin C supposed to go to pin 12 on the deutsch connector? You are correct on the wiring but I'm going to use a whisker switch on the implement instead of a switch in the cab. The bin sensor I have needs a ground, that is why I was hoping pin C was a ground. I have assumed that the bin sensor is closed when it senses product. If it is open I was going to use the relay trick, but now knowing that I can switch it on the monitor, I would probably wire them in parallel. The whisker switch can be wired as NO or NC so that shouldn't be a problem. Thanks again for the help. | |
|
Ag Leader App Rate Distribution Cable
