AgTalk Home
AgTalk Home
Search Forums | Classifieds (144) | Skins | Language
You are logged in as a guest. ( logon | register )

What hardware does it take to make a Pro 700 run liquid fertilizer on a planter?
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Trimble Man
Posted 2/10/2019 05:16 (#7310345 - in reply to #7308724)
Subject: RE: What hardware does it take to make a Pro 700 run liquid fertilizer on a planter?


Australia.
GOOSEPILOT - 2/10/2019 01:54

Keep in mind a pro6/700 CAN do a number of things. BUT can be VERY difficult and expensive to figure out. Not alot of support like other systems. If you figure it out, DO NOT update your monitor. If you do, you will likely have to start all over.

The guys that know monitors and vrt inside and out and write the rx software that i go to all say the same. Good F***ing luck with the pro 700


If you’re worried about updating firmware, just go with the CNH ISOBUS ECU. It is independant of the display and doesn’t need any software updating on the display when updating the ECU. If you want to do VR, then it’s Task Controller can use either ISOXML or std Shapefiles. (You may have to update the TC software to get the shapefile feature). It’s a lot simpler than using AccuControl.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)