|
| Am trying to install a brand new steer command and incommand 1200 into a new 2018 Case 340 CVT Magnum. Can get through the calibration until the dead band where it won’t go any further. When I try and examine the components the wheel angle sensor gives a reading but doesn’t change when I turn the steering wheel. When I go into the hydraulic valve and hit steer left or steer right it won’t move. I have 12v at the enable valve and have done a hard reset on the ecu. Checked all the pins on the plugs to make sure they are pushed through and tried multiple vehicle profiles and still no luck. Anyone have any ideas? | |
|
340 Magnum Steer Command
