AgTalk Home
AgTalk Home
Search Forums | Classifieds (8) | Skins | Language
You are logged in as a guest. ( logon | register )

Pro700 NMEA
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Trimble Man
Posted 1/30/2019 04:21 (#7283274 - in reply to #7283198)
Subject: RE: Pro700 NMEA


If it is an AccuGuide system, you will have to plug into the 12 pin Nav diagnostic connector. Pins 2 and 3 are tx/rx and pin 5 is gnd. Go into Toolbox - Nav and you can set up the individual nmea strings, including different rates, etc. (way more configurable than any Trimble displays). This is the prefered option, as it is terrain compensated gps.
You can also connect direct to the 262/372. Port A and B reconfigure themselves at each key cycle, to enable proper communications with the Nav and RTK Radio, so you will have to connect to Port C. The pins for Port C are in the physical port B. 6 is TX, 8 is RX and 5 is gnd. You can configure Port C output via Diagnostics - RDI in the Pro700. There are only 3 ports on a 262/372.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)