AgTalk Home
AgTalk Home
Search Forums | Classifieds (119) | Skins | Language
You are logged in as a guest. ( logon | register )

Raven viper pro new leader spinner speed
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Tsublake
Posted 1/25/2019 09:49 (#7271391)
Subject: Raven viper pro new leader spinner speed


North Central Texas
Anyone here have any experience with a Raven viper controlling a new leader single product spreader. We had an issue last year where the controller wouldn’t recognize the spinner speed node until we re addressed the nodes. After we did that, our spinner speed reading was way off. We had to change the calibration factor to 87 from 40 to get a proper speed reading. This factor is based off the number of bolt heads the sensor reads X 10 so 4 bolt should be a factor of 40. We have verified the spinner speed with both a mechanical and laser hand held tachometer. We have also replaced the node and it did not change.

It is working setup like this but our concern is that it it goes back to reading properly that the spinners will slow down without us noticing and make a mess of application. Thanks in advance.

Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)