|
East Central, Nebraska | i was wondering if anyone did a non cnh/trimble steering install on a newer steer ready tractor. the tractors have switches installed to enable steering but typically i have seen (especially agleader) that the switch is not utilized by that equipment. i would like to utilize this switch on two different tractors. has anyone done this? any suggestions for the cleanest way to do it?
this is using steer commands.
i had trimble systems in these tractors originally and no really see the value in using those buttons instead of the footswitch.
Edited by caseihfarmer 1/15/2019 10:07
| |
|