|
Beresford SD | That's a nifty deal
I have a Cat 262 wheeled. It has forced the procedure to be: set bale on end on the ground, back away, get out remove wrap, open gate. Get in loader pick up bale as is drive in yard approach feeder. Set bale down on ground outside of feeder, tip it so original ground contact area is on the ground, then spear the bale a bit above center. Pick up bale to put in feeder, normally the rotted hay on bottom of bale falls off , place bale in feeder, drive back out of yard, set loader on ground exit machine close gate.
The driver risks on this procedure involve climbing in and out of loader, but with loader in down position safety is maximized and I don't worry about the bale falling on someone. | |
|