Posted 12/6/2018 16:09 (#7153479) Subject: Nh3 side dress applicator
I have a 3 shank anhydrous bar with coulters, mole knives on chisel plow shanks, and disc sealers putting 180-200 lb actual N on 60 inch centers @ 5 mph for side dress application. This is in long term notil mostly level to some hills. The knives will run about where the mounting bolts are most of the time but the depth does not seem to matter. I have some trouble getting the anhydrous sealed with the current setup.
Would any of the high speed units seal better? If so, which ones would you recommend? Thanks, Jim