AgTalk Home
AgTalk Home
Search Forums | Classifieds (191) | Skins | Language
You are logged in as a guest. ( logon | register )

ITC bracket photo for JD 8030 series ?
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
flyboytoo
Posted 12/3/2018 05:30 (#7144977 - in reply to #7144908)
Subject: RE: ITC bracket photo for JD 8030 series ?


ec. nebr.
No, you have to drill the holes and take the roof off to put the nuts on. I made a matching plate for the inside to make the plastic roof stronger. Big washers would maybe also work on the underside? Make sure you center it as best you can before you drill, otherwise you will need to program an offset into your monitor to get a good line in both directions. This is not a very hard project at all! Just a little time and patience.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)