|
Eastern Nebraska | So I have all my equipment needed to complete my auto steer ready tractor (nav controller and 252 receiver), hopefully. It’s going on a Magnum 340. Is there any installation instructions out there that I can use to make sure I’m doing everything right? Back where the nav controller is there’s two connectors that are labeled P4 display. They would connect to each other but I’m not sure if they are supposed to be connected. Also on the roof there’s two connectors that are the same, how do I know which one is used for port a on the receiver? Is there a wiring schematic that would help? Any help would be appreciated. Thanks
Edited by Red Blood 11/30/2018 05:07
(36AC72B2-DC47-4B85-9713-E0641957D217 (full).jpeg)
(A6E8A825-3AA6-4C78-B69A-785C9A28B7AD (full).jpeg)
(09051374-ECC9-4FE3-8BCF-B0CC19FB76B1 (full).jpeg)
Attachments ---------------- 36AC72B2-DC47-4B85-9713-E0641957D217 (full).jpeg (118KB - 112 downloads) A6E8A825-3AA6-4C78-B69A-785C9A28B7AD (full).jpeg (163KB - 117 downloads) 09051374-ECC9-4FE3-8BCF-B0CC19FB76B1 (full).jpeg (169KB - 102 downloads)
| |
|