|
NW IA | Going to be pulling a 19 knife nh3 bar this fall. It is currently setup on Raven rate controller with 3 section shutoffs. Its all controlled by a Envizio Pro monitor. Im wondering what it would take to have my 2630 do all the communicating? Ive read about Raven having an ISO system that plugs and plays, but not sure if that works on what i have? Or do i have to rewire the whole bar for a JD rate controller? My other option would be a raven viper pro. Can i just swap the monitors from the envizio pro and just plug right in the viper pro? Or is there more to that? Would really prefer the Deere to be my primary, (just because it will be doing the autosteer) but open to the others.
2014 9460R
2015 19 knife B&B bar
2630 monitor for autosteer
Sf2, section control
Edited by IowaFarmer20 10/14/2018 15:46
| |
|