West KY | TD15 - 10/8/2018 09:59
I did it with my 750 to 2630. I think Deere only accepts 6 digits for the Nema settings. I think if you search this forum you could find the old thread for it.
Brown box will only be 6 digit precision. You need to be on 19200 baud rate with GSA GGA and RMC art at 5Hz.
Non-John Deere GPS Receivers
AutoTrac requires CAN GPS messages from an original StarFire receiver or StarFire iTC receiver.
Non-John Deere GPS receivers that output correct NMEA 0183 standard messages can be used for
documentation and manual guidance with a GreenStar application. It is critical that receiver is setup to output
the following messages:
· GGA
· GSA
· RMC setup at 19200 baud (This is fixed and
Non-adjustable)
· Data Bits 8
· Parity none
· Stop 1
· Flow Control none
· 1 or 5 Hz output rate (Recommend operation at 5
Hz. Guidance requires 5 Hz.)
Without these messages, receiver will not function with
GreenStar application. A harness and installation
instructions is available to connect DB9 port of receiver
to correct pins of display connector. |