silversurfer - 10/1/2018 21:14
Have two errors popping up on my Incommand 1200 in my 98’ R62 flow module and moisture module. Getting amber light on the flow sensor and speed sensor but red light on the moisture module. The display shows a green check mark beside all three. Checked the can cables by tugging on the connections. All were fine. Wondering if it could be a terminator or if it may be the moisture module itself. I haven’t checked continuity yet or homed the wiring. Are there any wiring schematics available? What pins I should be getting power at or what I should be getting for resistance on the wires? Any suggestions would be much appreciated.
Have you tried forcing the firmware to them again?? Might help |