|
| I have been having Integra CAN communication issues on our combine. We have been dropping CAN communication on all three modules at the same time. Our system "Y's" off right behind the main display cable and the CAN lines go there own ways from there. Logically to me, since we are dropping all three modules, the problem has to be in the display cable CAN connection, the cable itself or the Integra because I am thinking that the CAN connection aren't dependent on each other further down the line. In other words a bad conection near the module at the end of the link, won't cause the other modules to fail to communicate. Am I thinking of this correctly? Switched out the display cable last week and thought i figured out the issue but now it's back.
Thank you. | |
|
Integra question for the CAN experts
