|
Nesd | I just began using my edge in the combine (6620 deere) for yield monitoring as i was running it only in the sprayer. I have everything working except the mapping. I am only able to get yield data if i set primary speed to wheel sensor. When i have gps as primary, i get no yield data and am unable to get yield maps to write. In the diagnoatics it shows my lat, long and elevation but not getting a speed reading from it
Second question is, is it ok to re calibrate moisture after i have combined some crop? It is about 1.5% higher than the actual moisture. Didnt know if it would mess up anything ive already combined. Thanks in advance for any replies! | |
|